国产精品成人VA在线观看-国产乱妇乱子视频在播放-国产日韩精品一区二区三区在线-国模精品一区二区三区

參數資料
型號: W62410
廠商: WINBOND ELECTRONICS CORP
元件分類: 數字信號處理
英文描述: A Digital Speech Signal Processor(數字語音信號處理器)
中文描述: 8-BIT, 24.576 MHz, OTHER DSP, PQFP100
封裝: 14 X 20 MM, 2.75 MM HEIGHT, PLASTIC, QFP-100
文件頁數: 31/147頁
文件大小: 1932K
代理商: W62410
NO.:
W62410 API
VERSION:
A
PAGE
31
The above information is the exclusive intellectual property of Winbond Electronics and shall not be
disclosed, or reproduced without permission from Winbond.
W
= 1 bit, set high to indicate that the maximum allowed recording time has almost been
reached or has been exceeded (see
SetMaxLengthRecording
command for more
information).
= 1 bit indicating that CallerID information is present. If set to “1” then CallerID
information has been received, decoded and stored inside the CHIPSET and can be
requested by the host.
= 1 bit indicating that the data of the CallerID information could be corrupt because the
calculated and received CRC checksums didn’t match. If set to “1” then the CallerID
information is possible corrupt.
= 1 bit indicating if a certain energy level has been exceeded during the last 30
milliseconds. This bit will be reset immediately again when the energy drops below the
predefined threshold. This can be used as a VAD (Voice Activity Detector). The
threshold is predefined by the “VAD threshold” parameter. The energy is calculated
over the full frequency band.
= 1 bit specifying if a continuous tone has been detected for at least “continuous tone
time” times 30 milliseconds. The “C” flag will only be set to “1” after this
predetermined period of time. The threshold is defined by the “Continuos Tone
coefficient” parameter. This bit will be reset immediately again to “0” when the
continuous tone disappears.
= 1 bit specifying if a tone has been detected within the bandpass frequency during the
last 30 milliseconds (“1” = detected). This bit will be reset immediately again when the
energy drops below the defined threshold. The threshold is defined by the “continuous
tone coefficient” parameter. The energy is calculated after going through a bandpass
filter (300 Hz to 720 Hz).
= 1 bit, indicating a incoming DTMF tone present (“1” = DTMF tone is present). The
sensitivity is predefined by the “DTMF Tone sensitivity” parameter.
DTMF-code
= 4 bits specifying the received DTMF code. Only valid if the “D” flag is set.
I
F
V
C
P
D
相關PDF資料
PDF描述
W65C02S Microprocessor
W65C02S6P-14 Microprocessor
W65C02S6PL-14 Microprocessor
W65C02S6Q-14 Microprocessor
W65C02S8P-14 Microprocessor
相關代理商/技術參數
參數描述
W624LS 制造商:LUMINIS 制造商全稱:LUMINIS 功能描述:Post top mount
W6250ASX-1 功能描述:固態繼電器-工業安裝 90-280VAC/240AC RoHS:否 制造商:Crydom 控制電壓范圍:4 VDC to 32 VDC 負載電壓額定值:7 VDC to 72 VDC 負載電流額定值:160 A 觸點形式: 輸出設備:SSR 安裝風格:Panel
W6250DSX-1 功能描述:固態繼電器-工業安裝 3-32 VDC/240AC RoHS:否 制造商:Crydom 控制電壓范圍:4 VDC to 32 VDC 負載電壓額定值:7 VDC to 72 VDC 負載電流額定值:160 A 觸點形式: 輸出設備:SSR 安裝風格:Panel
W626 制造商:LUMINIS 制造商全稱:LUMINIS 功能描述:Post top mount
W626LS 制造商:LUMINIS 制造商全稱:LUMINIS 功能描述:Post top mount