- 您現在的位置：買賣IC網 > PDF目錄363893 > W66910CD (WINBOND ELECTRONICS CORP) TE Mode ISDN S/T-Controller with Microprocessor Interface PDF資料下載
參數資料
| 型號： | W66910CD |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 通信及網絡 |
| 英文描述： | TE Mode ISDN S/T-Controller with Microprocessor Interface |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP100 |
| 封裝： | 14 X 20 MM, 1.40 MM HEIGHT, QFP-100 |
| 文件頁數： | 39/81頁 |
| 文件大小： | 681K |
| 代理商： | W66910CD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
Data Sheet
W66910 PCI ISDN S/T-Controller
Publication Release Date:
Feb,2001
Revision 1.0
-39 -
B1
B2
Monitor
D
C/I
MR
MX
1
st
Octet 2
nd
Octet 3
rd
Octet 4
th
Octet
DD,DU : 768 kbits/s
FSC
DCL
: 8 kHz
: 1536 kHz
FIG 7.8 GCI MODE CHANNEL STRUCTURE
GCI slave mode
: connects to U transceiver such as PEB 2091, CH0 is used only.
GCI master mode
: connects to PSB 2165 ARCOFI, uses B1, B2, IC1 and IC2 for voice communication, uses MON1 for
programming, uses C/I1 for pins SA-SD access.
7.8.1 GCI Mode C/I0 Channel Handling
The Command/Indication channel 0 carries real-time status information between the W66910 and another device connected to
the GCI bus interface.
One C/I0 channel conveys the commands and indications between a layer 1 device and layer 2 device. This C/I0 channel is
accessed via register CIR (in receive direction, layer 1 to layer 2) and register CIX (in transmit direction, layer 2 to layer 1). The
C/I code is 4-bit long.
In the receive direction, the code from layer 1 is continuously monitored, with an interrupt being generated anytime a
change occurs. A new code must be found in two consecutive GCI frames to be consided valid and to trigger a C/I code
change interrupt status (double last look criterion).
In the transmit direction, the code written in CIX is continuously transmitted in the channel.
7.8.2 GCI Mode Monitor Channel Handling
The Monitor channel protocol is a handshake protocol used for high speed information exchange between the W66910 and other
devices. The Monitor channel is necessary for:
Programming and controlling devices attached to the GCI interface.
Data exchange between two microprocessor systems attached to two different devices on one GCI backplane. Use of the
Monitor channel avoids the necessity of a dedicated serial communication path between two systems.
The Monitor channel operates on an asynchronous basis. While data transfers on the bus take place synchronized to frame sync,
the flow of data is controlled by a handshake procedure using the Monitor Channel Receiver (MOR) and Monitor Channel
Transmit (MOX) bits. When data is placed into the Monitor channel and the MX bit is activated. This data will be transmitted
repeatedly once per 8 KHz frame until the transfer is acknowledged via the MR bit.
相關PDF資料 |
PDF描述 |
|---|---|
| W6691 | ISDN S/T Interface Transceiver |
| W6691CD | ISDN S/T Interface Transceiver |
| W6691CP | ISDN S/T Interface Transceiver |
| W6692 | PCI Bus ISDN S/T Interface Controller(PCI總線的ISDN S/T接口控制器) |
| W6693A | USB Bus ISDN S/T Interface Controller(USB總線的ISDN S/T接口控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W6691CD | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ISDN S/T Interface Transceiver |
| W6691CP | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ISDN S/T Interface Transceiver |
| W6692 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:PCI Bus ISDN S/T-Controller |
| W6692A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TE Mode S/T Controller with PCI 2.2 Interface and ACPT |
| W6692ACD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ISDN LINE INTERFACE|BASIC|CMOS|QFP|100PIN|PLASTIC |
發布緊急采購，3分鐘左右您將得到回復。