- 您現在的位置：買賣IC網 > PDF目錄363895 > W77C58 (WINBOND ELECTRONICS CORP) 8 BIT MICROCONTROLLER PDF資料下載
參數資料
| 型號： | W77C58 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 8位微控制器 |
| 英文描述： | 8 BIT MICROCONTROLLER |
| 中文描述： | 8位微控制器 |
| 文件頁數： | 6/71頁 |
| 文件大小： | 516K |
| 代理商： | W77C58 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
Preliminary W77C58
- 6 -
Data Pointers
The original 8052 had only one 16-bit Data Pointer (DPL, DPH). In the W77C58, there is an additional
16-bit Data Pointer (DPL1, DPH1). This new Data Pointer uses two SFR locations where were unused
in the original 8052. In addition there is an added instruction, DEC DPTR (op-code A5H), which helps
in improving programming flexibility for the user.
Power Management
Like the standard 80C52, the W77C58 also has IDLE and POWER DOWN modes of operation. The
W77C58 provides a new Economy mode, which allows user to switch the internal clock rate divided
by 4, 64 or 1024. In the IDLE mode, the clock to the CPU core is stopped while the timers; serial ports
and interrupts clock continue to operate. In the POWER DOWN mode, the entire clock is stopped and
the chip operation is completely stopped. This is the lowest power consumption state.
On-chip Data SRAM
The W77C58 has 1K Bytes of data space SRAM that is read/write accessible and is memory mapped.
This on-chip MOVX SRAM is reached by the MOVX instruction. It is not used for executable program
memory. There is no conflict or overlap among the 256 bytes Scratchpad RAM and the 1K Bytes
MOVX SRAM as they use different addressing modes and separate instructions. Setting the DME0 bit
in the PMR register enables the on-chip MOVX SRAM. After a reset, the DME0 bit is cleared such
that the on-chip MOVX SRAM is disabled, and all data memory spaces 0000H
FFFFH access to the
external memory.
MEMORY ORGANIZATION
The W77C58 separates the memory into two separate sections, the Program Memory and the Data
Memory. The Program Memory is used to store the instruction op-codes, while the Data Memory is
used to store data or for memory mapped devices.
Program Memory
The Program Memory on the W77C58 can be up to 64K bytes long. All instructions are fetched for
execution from this memory area. The MOVC instruction can also access this memory region.
Data Memory
The W77C58 can access up to 32Kbytes of external Data Memory. This memory region is accessed
by the MOVX instructions. Unlike the 8051 derivatives, the W77C58 contains on-chip 1K bytes MOVX
SRAM of Data Memory, which can only be accessed by MOVX instructions. These 1K bytes of SRAM
are between address 0000H and 03FFH. Access to the on-chip MOVX SRAM is optional under
software control. When enabled by software, any MOVX instruction that uses this area will go to the
on-chip RAM. MOVX addresses greater than 03FFH automatically go to external memory through
Port 0 and 2. When disabled, the 1KB memory area is transparent to the system memory map. Any
MOVX directed to the space between 0000H and FFFFH goes to the expanded bus on Port 0 and 2.
This is the default condition. In addition, the W77C58 has the standard 256 bytes of on-chip
Scratchpad RAM. This can be accessed either by direct addressing or by indirect addressing. There
are also some Special Function Registers (SFRs), which can only be accessed by direct addressing.
Since the Scratchpad RAM is only 256 bytes, it can be used only when data contents are small. In the
event that larger data contents are present, two selections can be used. One is on-chip MOVX SRAM,
the other is the external Data Memory. The on-chip MOVX SRAM can only be accessed by a MOVX
instruction, the same as that for external Data Memory. However, the on-chip RAM has the fastest
access times.
相關PDF資料 |
PDF描述 |
|---|---|
| W77E058A40DL | 8-BIT MICROCONTROLLER |
| W77E058A40FL | 8-BIT MICROCONTROLLER |
| W77E058A40PL | 8-BIT MICROCONTROLLER |
| W77E058A | 8-BIT MICROCONTROLLER |
| W77E468F-25 | 8 BIT MICROCONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W77E058A | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-BIT MICROCONTROLLER |
| W77E058A40DL | 功能描述:IC MCU 8-BIT 32K FLASH 40-DIP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:W77 標準包裝:250 系列:80C 核心處理器:8051 芯體尺寸:8-位 速度:16MHz 連通性:EBI/EMI，I²C，UART/USART 外圍設備:POR，PWM，WDT 輸入/輸出數:40 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-LCC（J 形引線） 包裝:帶卷 (TR) |
| W77E058A40FL | 功能描述:IC MCU 8-BIT 32K FLASH 44-PQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:W77 標準包裝:250 系列:80C 核心處理器:8051 芯體尺寸:8-位 速度:16MHz 連通性:EBI/EMI，I²C，UART/USART 外圍設備:POR，PWM，WDT 輸入/輸出數:40 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-LCC（J 形引線） 包裝:帶卷 (TR) |
| W77E058A40PL | 功能描述:IC MCU 8-BIT 32K FLASH 44-PLCC RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:W77 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN，SCI，SPI 外圍設備:POR，PWM，溫度傳感器，WDT 輸入/輸出數:21 程序存儲器容量:40KB（20K x 16） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323 |
| W77E11 | 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:EXECUTION EX. NO.1 DX CODE ZA |
發布緊急采購，3分鐘左右您將得到回復。