- 您現在的位置：買賣IC網 > PDF目錄2139 > ADA4830-2BCPZ-R7 (Analog Devices Inc)IC AMP BATT PROTECT DUAL 16LFCSP PDF資料下載
參數資料
| 型號： | ADA4830-2BCPZ-R7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 10/23頁 |
| 文件大小： | 0K |
| 描述： | IC AMP BATT PROTECT DUAL 16LFCSP |
| 標準包裝： | 1 |
| 放大器類型： | 差分 |
| 電路數： | 2 |
| 轉換速率： | 220 V/µs |
| -3db帶寬： | 84MHz |
| 電流 - 電源： | 6.8mA |
| 電流 - 輸出 / 通道： | 125mA |
| 電壓 - 電源，單路/雙路(±)： | 2.9 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 16-LFCSP-WQ（3x3） |
| 包裝： | 標準包裝 |
| 其它名稱： | ADA4830-2BCPZ-R7DKR |
Data Sheet
ADA4830-1/ADA4830-2
Rev. C | Page 17 of 22
DRIVING CAPACITIVE LOADS
The ADA4830-1 and ADA4830-2 are capable of driving large
capacitive loads while maintaining its rated performance.
Several performance curves vs. capacitive load are shown in
Figure 12 and Figure 25. Capacitive loads interact with an op amp’s
output impedance to create an extra delay in the feedback path.
This reduces circuit stability and can cause unwanted ringing
and oscillation.
The capacitive load drive of the ADA4830-1and ADA4830-2 can
be increased by adding a low valued resistor, RS, in series with the
capacitive load. Figure 35 shows the test circuit.
ADA4830-1
+
–
CL = 47pF
RS = 49.9
RL = 1k
10020-
052
Figure 35. RS Test Circuit
Introducing a series resistor tends to isolate the capacitive load
from the feedback loop, thereby diminishing its influence. One
drawback to this approach is a slight loss of signal amplitude.
Figure 36 shows the effects of a series resistor on the capacitive
drive. For very large capacitive loads, the frequency response of
the amplifier is dominated by the roll-off of the series resistor
and capacitive load.
1.0
1.5
2.0
2.5
3.0
3.5
4.0
0
50
100
150
200
250
V
O
UT
(V)
TIME (ns)
10020-
135
+VS = 5V
RL = 1kΩ
CL = 47pF
NO RS
RS = 49.9
Figure 36. Pulse Response With and Without Series Resistor
Another method of reducing the resonant peaking caused by
driving large capacitive loads at the output of the ADA4830-1
and ADA4830-2 is with the use of a R-C shunt circuit or a snubber
circuit. This method acts to resistively load the amplifier output,
thus reducing frequency response peaking. One drawback to this
approach is a slight loss of signal bandwidth. Figure 37 shows a
simple circuit representation of the implementation of the R-C
a R-C snubber circuit driving 47 pF, where RSNT = 73.2 and CSNT
= 0.1 F.
ADA4830-1
+
–
CL = 47pF
CSNT = 0.1uF
RL = 1k
RSNT = 73.2
10020-
053
Figure 37. R-C Test Circuit
1.0
1.5
2.0
2.5
3.0
3.5
4.0
0
50
100
150
200
250
V
O
UT
(V)
TIME (ns)
10020-
137
+VS = 5V
RL = 1kΩ
CL = 47pF
NO SNUBBER
CIRCUIT
RSNT = 73.2Ω
CSNT = 0.1F
Figure 38. Pulse Response With and Without R-C Snubber Circuit
相關PDF資料 |
PDF描述 |
|---|---|
| ADA4841-2YRZ-R7 | IC OPAMP VF R-R DUAL LP LN 8SOIC |
| ADA4850-2YCPZ-R2 | IC OPAMP VF R-R DUAL 16LFCSP |
| ADA4851-4YRUZ | IC OPAMP VF R-R QUAD LP 14TSSOP |
| ADA4855-3YCPZ-R7 | IC OPAMP VF R-R TRPL LP 16LFCSP |
| ADA4857-2YCPZ-RL | IC OPAMP VF DUAL ULDIST 16LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4830-2WBCPZ-R7 | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Speed Difference Amplifier with Input |
| ADA484 | 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit, 1 MSPS PulSAR ADC in MSOP QFN |
| ADA4841 | 制造商:AD 制造商全稱:Analog Devices 功能描述:14-Bit, 500 kSPS PulSAR ADC in MSOP |
| ADA4841-1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit Lower Power |
| ADA4841-1YR-EBZ | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Low Noise and Distortion ail-to-Rail Output Amplifiers |
發布緊急采購，3分鐘左右您將得到回復。