- 您現在的位置：買賣IC網 > PDF目錄369215 > 600I25 (Linear Technology Corporation) Very Low Noise, Differential Amplifier and 2.5MHz Lowpass Filter PDF資料下載
參數資料
| 型號： | 600I25 |
| 廠商： | Linear Technology Corporation |
| 元件分類： | 差分放大器 |
| 英文描述： | Very Low Noise, Differential Amplifier and 2.5MHz Lowpass Filter |
| 中文描述： | 極低噪聲，差分放大器和2.5MHz的低通濾波器 |
| 文件頁數： | 4/12頁 |
| 文件大小： | 177K |
| 代理商： | 600I25 |
LT6600-2.5
4
660025i
PIU
IN
–
and IN
+
(Pins 1, 8):
Input Pins. Signals can be applied
to either or both input pins through identical external
resistors, R
IN
. The DC gain from differential inputs to the
differential outputs is 1580
/R
IN
.
V
OCM
(Pin 2):
Is the DC Common Mode Reference Voltage
for the 2nd Filter Stage. Its value programs the common
mode voltage of the differential output of the filter. Pin 2 is
a high impedance input, which can be driven from an
external voltage reference, or Pin 2 can be tied to Pin 7 on
the PC board. Pin 2 should be bypassed with a 0.01
μ
F
ceramic capacitor unless it is connected to a ground plane.
V
+
and V
–
(Pins 3, 6):
Power Supply Pins
.
For a single
3.3V or 5V supply (Pin 6 grounded) a quality 0.1
μ
F
ceramic bypass capacitor is required from the positive
supply pin (Pin 3) to the negative supply pin (Pin 6). The
bypass should be as close as possible to the IC. For dual
supply applications, bypass Pin 3 to ground and Pin 6 to
ground with a quality 0.1
μ
F ceramic capacitor.
OUT
+
and OUT
–
(Pins 4, 5):
Output Pins
.
Pins 4 and 5 are
the filter differential outputs. Each pin can drive a 100
and/or 50pF load to AC ground.
V
MID
(Pin 7):
The V
MID
pin is internally biased at mid-
supply, see block diagram. For single supply operation,
the V
MID
pin should be bypassed with a quality 0.01
μ
F
ceramic capacitor to Pin 6. For dual supply operation, Pin
7 can be bypassed or connected to a high quality DC
ground. A ground plane should be used. A poor ground
will increase noise and distortion. Pin 7 sets the output
common mode voltage of the 1st stage of the filter. It has
a 5.5k
impedance, and it can be overridden with an
external low impedance voltage source.
相關PDF資料 |
PDF描述 |
|---|---|
| 60APU06 | ULTRAFAST SOFT RECOVERY DIODE |
| 60EPU06 | ULTRAFAST SOFT RECOVERY DIODE |
| 60CDQ045 | 60 Amp Schottky Rectifier(60 A肖特基整流器) |
| 60CDQ035 | 60 Amp Schottky Rectifier(60 A肖特基整流器) |
| 60CDQ040 | 60 Amp Schottky Rectifier(60 A肖特基整流器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 600J | 制造商:BRKLYN 功能描述: 制造商:Marathon Special Products 功能描述: |
| 600JE | 制造商:OHMITE 制造商全稱:Ohmite Mfg. Co. 功能描述:Two Terminal Metal Element Current Sense |
| 600JJ 16 | 制造商:MARATHON 功能描述:TERMINAL BLOCK, BARRIER, 16POS, 22-12AWG; Connector Type:(Not Available); Series:-; Connector Mounting:(Not Available); Contact Plating:(Not Available); Contact Material:(Not Available); Approvals / Standards:(Not Available) ;RoHS Compliant: Yes 制造商:MARATHON 功能描述:TERMINAL BLOCK, BARRIER, 16POS, 22-12AWG; Series:-; Approvals / Standards:(Not Available); No. of Positions:16 ;RoHS Compliant: Yes |
| 600-JJ-01 | 制造商:Marathon Special Products 功能描述: |
| 600-JJ-02 | 制造商:Marathon Special Products 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。